Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
★★★★★
★★★★★
Sylvie H - February 14, 2019
Verified Purchase
fast delivery
The part was exactly what I needed and delivered faster than expected.
< Prev
1
Next >
Customer Repair Stories
Average Repair Rating: 4.1 / 5.0, 5 reviews.
What's this?
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Plastic clips had broken, causing bottom skirt piece to fall off.
After attempting to order this part from Whirlpool twice and twice receiving the wrong thing, found correct part on PartSelect in about one minute. Shipment came fast and the repair was very simple, under five minutes. You just pop the pieces in place and snap the piece back onto the oven.
Other Parts Used:
William from Greensboro, NC
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
28 of 29 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Lower panal would not stay in place because plastic fastners were gone.
I inserted the door strikes in the proper position and then snapped the panel in place.
Other Parts Used:
siri from remsenburg, NY
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
4 of 5 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
1.Access Panel door strike broken. 2. 8" element operated at high heat only
1. Pressed new door strike into access panel replaced access panel. 2. Turned off power to stove at main power switch panel. Opened access panel and decoupled down draft fan discharge duct. Pulled range out of counter about 3 inches to clear instrument panel side plates. Removed knob from control switch. Removed 4 screws retaining trim at bottom of instrument panel. Removed 4 screws holding instrument panel in place. Lowered instrument panel. Rotated panel top outward to expose surface burner infinite control switches. Checked all connections to suspect control switch with voltmeter to ensure no residual voltages present. Held new switch in same position as installed switch and swapped connections one at a time. Removed two screws holding old switch in panel and removed old switch. Installed new switch in panel using the two screws removed. Re-assembled range in reverse order above and slide back into counter. Recoupled downdraft fan discharge duct and reattached access panel. Reattached conrol switch knob. Restored power to range at main power switch panel. Turned control switch to High until element was red hot. Turned control knob to Low and verified element heat was reduced normally. (Control switch failure was determined by changing stove top elements and experiencing the same high only heating and loss of heat control. A small jar was used to hold all screwa as removed.)
Ask our experts a question about this part and we'll get back to you as soon as possible!
2 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Don
January 30, 2019
I have a Jenn-Air model svd48600p and the lower access door has a male grommet on each side and one is missing. The female grommets are both in place on the oven side. I would be willing to purchase by the set or each however they are offerred but the one being listed in my cart looks like the female part and i need the male part shown as mfg part # wp71002097, the part select number is ps11743868. Please let me know what part number i should use to order this.Thanks,
don
For model number Jenn-Air SVD48600P
Hello Don, Thank you for your inquiry. After reviewing your model again I am able to confirm that PS11743868 is the correct part number. Thank you for your follow up and good luck with your repair!
2 people found this helpful.
Was this helpful?
Thank you for voting!
Don
January 30, 2019
Does this part come with the male clip that fits in the access door itself as shown as mfg part wp71002097. That is the part i nedd.Thanks
Hello Don, Thank you for contacting us. In order for us to locate the correct parts and repair information we will require the model number of the unit. Once you have located the model number please feel free to resubmit the question and we will be happy to help you. Look forward to hearing from you!
1 person found this helpful.
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this part and we'll respond as soon as we can.
