Average Repair Rating: 4.2 / 5.0, 3 reviews.
What's this?
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
The side hinge broke off due to the door sticking. so it wasn't covered under warrant.
first I removed the pantry drawer and the 2 crisper drawers. Then I removed the glass shelf and it's supports. Using a nut driver I removed the 2 screws holding the end cap to the side of the refrigerator. Carfully snaped the end cap loose of the clip in front and pulled it straight forward, being carful not to break the rear tabs holding the climate adjuster. I then removed the old climate adjuster from my broken part (it's held on by clips) and installed it on the new end cap. I put the new end cap in snapping it onto the existing clip and added the 2 screws. Put the shelf supports and glass back on top of the drawer, slid back in the crisper drawers, installed the divider into the drawer (it just slides in) then put the drawer back in and I was done. It was an easy job and I'm sure I saved at least one hundred dollors for 20 minutes work.
Easy repair here, the Refridge was purchased at a discount as a scratch and dent model. the damage was superfical and the parts orderd were simple remove and replace job did not take long at all to replace all parts.
Divider pantry: no tools required, simply pull out tray and remove old broken dividers and snap new divider in place. Brace-Crisper: this takes a screw driver to remove. remove the crisper shelf and insert a screw driver to lift the plastic securing tab. slide out the frame brace and slide the new brace in place the plastic tabs will snap in to place and hold the metal frame in its position. Grille, Toe: this grill snaps into place no tools required. Bracket: this is the metal bracket for the front feet, there are 4 screws to remove and the bracket comes off the front of the refridge. unsrew the adjustable screw foot and screw the adjustable screw foot into the new bracket......install the 4 screws and you are done. Trim-Shelf: no tools required simply pry the trim piece of with your fingers.....some may use a flat screw driver but this riskes scratching the trim piece. the new trim piece snaps into place.
followed instructions and used common sense and the salesman was very helpful and knowledgeable and he contributed a lot of help in finding the right parts that fit
Ask our experts a question about this part and we'll get back to you as soon as possible!
4 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Joyce
November 22, 2017
Is this the plastic divider between the two crisper drawers?
For model number KBFS25ETBL00
Hi Joyce, Thank you for the question. No this is the divider that sits inside the Pantry Drawer. The divider for the 2 crisper drawers is, Part Number: PS1632543. Good luck with the repair!
The small plastic tab broke on the one side of the deli drawer, that holds the lid in place. Is there anyway to replace it?
For model number mfi2670xem
Hi Erika. If it was a part of the drawer its self you would have to replace the entire drawer sadly. Thank you for your question and good luck with your repair!
Is this the correct divider for the pantry drawer for this model number?
For model number wrf555sdfz05
Hello Joseph,
Thanks for your question. The pantry drawer has been updated by the manufacturer and no longer has a divider compatible with it. The part number is PS11743537 for the drawer.
I hope this helps.
I asked if drawer divider wp67002759 was the correct part for my pantry drawer. You responded that the pantry drawer has been updated by the manufacturer and no longer has a divider compatible with it and that the part number is ps11743537 for the drawer. I ordered this divider anyway based on some of the dimensions provided in some appliance forums and it fit perfectly. Why is this part not listed for this drawer?
For model number WRF555SDFZ05
Hi Joseph,
Thank you for contacting us. That would be a question for the manufacturer. We list parts underneath model numbers that the manufacturer has approved and confirmed works with those models. If they have not let us know that a part will work we can never guarantee that a part not listed underneath your model information will work. I am very glad that this part worked out for you. Thank you for letting us know!
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this part and we'll respond as soon as we can.
This manufacturer-approved Refrigerator Pantry End Cap Kit, also known as the Refrigerator Drawer Support, is a kit containing all parts of the Pantry End Cap. It snaps into place on the appliance’s pantry drawer to hel...
Model Cross Reference
This part works with the following models:
PartSelect Number: PS11743508
Manufacturer Part Number: WP67002759
