Average Repair Rating: 2.9 / 5.0, 6 reviews.
What's this?
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Broken inner door glass
I removed all the screws attaching the inner liner to the door, then removed the broken glass. I did this before ordering the replacement glass so I could be sure that only one piece was broken -- the door contains four pieces of glass in all. After the replacement glass arrived (really fast delivery!), I cleaned all the parts and reassembled the door. I had some difficulty in aligning the screw holes properly, and I'm still not sure if I have the exterior sheet of glass positioned correctly -- the schematic shows the order in which the parts go together but not how they fit exactly. I should have inspected the door more closely before I took it apart. Anyway, it feels solid and everything seems to work.
Other Parts Used:
Elizabeth from Seattle, WA
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers
31 of 37 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Inner glass
Take door off completely by setting hinge locks into place and then removing door. Take all of the screws out from frame (remember that the flat screws go the outside and the raised heads on the inside of door)Remove the clips on the bottom of door as well. Carefully remove frame. Then remove the inner glass clips, this will allow you to remove the broke or cracked glass easily and install the new glass. Set the door on a soft towel with finish side down. Make sure your hinges are on the proper sides if you moved them. (you will see where the screw hole matches up with the bottom of the frame. Do everything in reverse to put back together. Good Luck
Other Parts Used:
Michael from Denville, NJ
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers
22 of 30 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Inner-most glass was broken
GENERAL APPROACH: 1) Checked YouTube for some general guidance: VERY helpful things there for this! PartSelect's install info. was helpful as well- Thank you for this! 2) had table set up in order to disassemble the door once it was removed 3) There are 4 separate glass panes in there- they all need to be cleaned 4) TOOK PICTURES AND MADE CAREFUL NOTES AS (12 or 15?) SCREWS ARE TINY & THERE ARE DIFFERENT TYPES. TAPED THEM NEAR WHERE I REMOVED THEM SO AS TO KEEP THINGS STRAIGHT 5) Like any project little or big, just take your time & it actually works out well 6) take advantage of this downtime to clean the oven good, as well as the door & panes of glass. Cleaning was 75% of this project. 7) EXTRA: If you're so inclined, turn the breaker off for the Oven & carefully remove the lower heating element to enable easier & more thorough cleaning of your oven. You'll be glad you did this- and so will your cook!
Other Parts Used:
MARK from ROCHESTER, NY
Difficulty Level:
A Bit Difficult
Total Repair Time:
More than 2 hours
Tools:
Screw drivers
2 of 2 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
broken inner glass from upper oven
Sorry but that would take too long to give all instructions, but I will mention that there were four glass plates if you count the cover of the door which is a large glass piece. All glass plates had to be taken out or off including the holder hardware in order to get to the inner glass (about 15 screws in all). No you-tube videos seemed to apply directly for this door. Taking some pics and using a card to hold screws in the pattern they were taken out helped keep the in order to be replaced (I screwed the screws into a paper sheet to keep the pattern with some labeling like top, bottom, etc). Lower glass door appears to only have two glass plates (didn't take it apart, but inner glass holders were not seen when peering in through the inner glass as they are in the upper door). If the inner glass plate on this door gets broken it should be easier. The glass was broken for some time before this repair so there was a lot of cleaning required inside the door. Oh, by the way, when taking out the door off pull out (not up) after locks are released and when the door is mostly closed. Push back in and open door down a bit to lock back in place. This is far from complete but I hope it helps some.
Other Parts Used:
Andrew from N LITTLE ROCK, AR
Difficulty Level:
A Bit Difficult
Total Repair Time:
More than 2 hours
Tools:
Screw drivers
2 of 2 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Upper oven door inside glass cracked vertically, top to bottom. A currently common problem I discovered.
Product Select was the only distributor to have the oven door glass in stock. Kitchen Aid could not even get it for months.
INSTRUCTIONS: Repaired the top over door glass quickly and easily by asking my son to do it.
Other Parts Used:
LAUREN from KENTFIELD, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
1 personfound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Replace inner glass
Only problem. stripped screw. Replaced at local hardware store. Directions were simple and easy.
Other Parts Used:
terrence from SCOTTSDALE, AZ
Difficulty Level:
Very Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers
1 personfound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
< Prev
1
Next >
Questions and Answers
Ask our experts a question about this part and we'll get back to you as soon as possible!
5 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Sharron
February 3, 2020
I need instructions on how to replace the inner door glass for my Whirlpool electric wall oven, model#rbs245pdb8. Most of the repair videos i have viewed do not address how to remove the oven door on older styled door hinges that do not simply slide out.
For model number 11742540
Hello and thank you for writing.
Try this. To remove oven doors: Open door to the BROIL POSITION, where you feel hinge catch slightly. Place your hands on both sides of the door near the handle. If the door does not readily lift off, there may be 2 Phillips head screws on the inside of the door down near the hinges that are holding it on. We hope this helps. Please contact us anytime if you require further assistance.
5 people found this helpful.
Was this helpful?
Thank you for voting!
Francis
January 7, 2019
Do you sell the complete door, glass installed? Do you have techs in 20735 zip code that can make repairs on site... in home?
For model number KEBC147KBL0
Hello Francis, Thank you for the question. Very sorry but we are a website based company that sells and ships appliance parts. We do not have technicians. The door is only sold as individual parts, the door is not sold as a complete assembly. Hope this helps, good luck with this repair!
2 people found this helpful.
Was this helpful?
Thank you for voting!
Jacob
March 24, 2023
I need to replace the middle glass shelf
For model number WRT311FZDW01
Hello Jacob, thank you for your question! The middle glass shelf is part number PS12584470. We hope this is what you were looking for!
Hello Jodie, Thank you for contacting us. I have researched the model you have provided and have found the part you are looking for is Part Number: PS11742540. Thank you for your inquiry, good luck with this repair!
Was this helpful?
Thank you for voting!
Wami
November 26, 2021
Would this part work for this model?
For model number WERP4120PS 1
Hello Wami, Thank you for your inquiry. We have researched the model number you have provided and show that this part is not listed as compatible. The compatible part number is PS11744843. We hope this helps.