This white female door catch is attached to the dryer door.
How Buying OEM Parts Can Save You Time and Money
Part Videos
Replacing your Whirlpool Dryer Dryer Door Catch
Troubleshooting
This part fixes the following symptoms:
Door won’t close | Door Pops Open
This part works with the following products:
Dryer, Washer Dryer Combo.
This part works with the following products:
Whirlpool, Kenmore, Maytag, Roper.
Part# WP3389441 replaces these:
AP6008299, 3389441
Customer Reviews
Average Rating:
★★★★★
★★★★★
8 Reviews
4.9
Filter By Rating:
5 Stars
7
4 Stars
1
3 Stars
0
2 Stars
0
1 Star
0
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
★★★★★
★★★★★
Ovidiu M - September 25, 2019
Verified Purchase
Exactly as original
The whole repair takes 5 min. you need a small flat screwdrive to extract the old ones. The replacement parts fits perfectly and now the dryer door stays closed.
★★★★★
★★★★★
John H - August 2, 2019
Verified Purchase
Broken female dryer door latch
The part was and works great fast service and quick delivery will use again and will tell friends and family
★★★★★
★★★★★
Jeremy G - August 2, 2020
Verified Purchase
Easy repair, works well.
Installed in seconds, works like new.
★★★★★
★★★★★
Mike F - February 26, 2019
Verified Purchase
Worked as expected
Quick fix door catch came within a few days of ordering, perfect fit
★★★★★
★★★★★
Eric S - September 7, 2020
Verified Purchase
Worked as expected
The part was correct
★★★★★
★★★★★
Jim V - April 21, 2021
Verified Purchase
Right part, easy fix
Part was exactly as indicated on website.
★★★★★
★★★★★
Kim W - August 14, 2018
Verified Purchase
Part arrived as ordered and worked perfectly
This was an easy fix. The appliance repairman had told me that the part was no longer available and that I would either need to start taping the dryer shut or buy a new dryer. Luckily the part was available through PartSelect. It arrived as ordered and was an easy fix, even for me. Fantastic.
★★★★★
★★★★★
James L - March 25, 2021
Verified Purchase
Part was correct for dryer
I initially didn’t pay enough attention when removing old part but figured it out ,works good
< Prev
1
Next >
Customer Repair Stories
Average Repair Rating: 4.6 / 5.0, 7 reviews.
What's this?
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Top door catch assembly had broken
It was so easy, that my wife did it the day we got the part before I got home from work. She wedged it out with a flat head screw driver and then pushed the new door catch assembly in with her thumb. Pretty simple, thanks for having parts like this available to the public!
Other Parts Used:
tony from prineville, OR
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
29 of 31 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
dryer door would not latch
my dryer door didn't latch for over a year. We were accustom to proping large objects against it. a friend told me to look on line. The close up pictures and parts diagrams were awesome. It was here in 4 days . Now my family thinks I am a hero. The end
Other Parts Used:
Robert from Livermore, ME
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
13 of 15 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The plastic handle use to open the door broke.
Go to you tube to see how easy it is to fit the new handle. . It was a snap!
plastic female latch part had broken...door would not stay shut
It was so easy... Pop out the old with flatblade screw driver and insert new piece... Works perfectly and looks better than the velcro strip I was using to hold the door shut...! Thanks for fast delivery and having the part available...
Regards, JBL
Other Parts Used:
JOHN from HENDERSONVILLE, NC
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
8 of 9 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Door was popping open
Watch the video before I received the part. Made it very simple to replace and which screws to take out.
Other Parts Used:
Harry from OTSEGO, MI
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers, Screw drivers
3 of 4 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Washing machine stopped 1/2 way through cycle
Online repair tips already listed are pretty accurate, however I did have a little difficulty getting the control panel to lift up. I didn't realize that the two screws recessed at the back of the machine needed to be all the way out before it would move. It doesn't swivel or twist as the previous directions said. you have to shove the entire control panel backwards to slip the hooks out of the slots before you can pick it up and move it out of the way. Once you have that lifted you can get to two brass straps that have to pop out of the top of the machine before the back panel and the front housing can separate. Disconnect the plastic connection to the control switch before you attempt to move the housing. After I got that far it was very easy to replace the old switch with the new one. One screw on the grounding wire and one clip holding it in place along the top of the machine and that's it! Once you get the repair done the operation is done in reverse. The only thing you need to be sure and do is to make sure the notches at the bottom of the machine match up to the slots on the housing otherwise the entire housing is very unstable if you try to move the machine, the fill tube doesn't sit correctly, and the tub isn't in the correct position. In that case take it apart again and try to get the slots and notches matched back up,
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
4 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Gary
January 14, 2022
Door catch pin won't engage far enough into plastic catch to keep door closed
For model number MEDB765FWO
Hello Gary, thank you for your question. Based on your model number, we find the part to be the Strike PartSelect Number PS12723934. Or you may need to replace the door catch as well as they work together. We hope to hear from you soon
Looking for the part of the dryer door that keeps the door closed
For model number MB2322066
Hello Sharon, thank you for your question. We suggest the Door Catch Kit PS334230. This kit contains two door strikes, and three door catches to service dryer doors that have one or two catches. We hope to hear from you soon
I need the part on the top right corner on dryer door opening that the door catches on or where the light comes on.
For model number MED5707TQ0
Hello Elmer, Thank you for contacting us. We have researched the model you have provided and have found the part you are looking for is PartSelect Number PS11741434. If you need help placing an order, customer service is open 7 days a week. Please feel free to give us a call. We look forward to hearing from you!
Was this helpful?
Thank you for voting!
Maisie
April 28, 2022
Hi, I'm looking for a female door latch for the Kenmore model number listed above. Do you carry this Thanks!
For model number 11086030120
Hello Maisie, Thank you for contacting us. We have researched the model you have provided and have found the part you are looking for is PartSelect Number PS334230 and is only sold as a kit. If you need help placing an order, customer service is open 7 days a week. Please feel free to give us a call. We look forward to hearing from you!
Fresh Flow Produce Preserver is made for your refrigerator to help keep produce fresh for longer by absorbing the chemical, ethylene, that causes your fruits and vegetables to ripen quicker. Your produce could be fresh f...
This front load washer cleaner removes odor-causing residue. Use it once a month and it will keep your machine fresh and clean. Package comes with 3 tablets.
Affresh dishwasher Cleaner is specially formulated to help remove limescale and mineral build-up that can be unsightly and could affect your dishwasher's performance. Each tablet is designed to clean inside your machine ...
Make your cooktop shine with Frigidaire ReadyClean Glass and Ceramic Cleaner. Our scratch-free, streak-free formula removes smudges, grease, burnt-on food, dirt and oil, while protecting and polishing to repel dust and d...
Affresh® Dishwasher Cleaner is the #1 recommended cleaner by Whirlpool, KitchenAid, and Maytag brands, designed to remove limescale and mineral build-up that can affect your dishwasher’s performance. These powerful table...
Model Cross Reference
This part works with the following models:
PartSelect Number: PS11741434
Manufacturer Part Number: WP3389441
