Tall Baffle

removed door, removed screws to lift top panel, removed screws that held old baffles, replaced with new baffles, took off front panel and cleaned out excess lint while I was in there.

take 2 phillips screws out where door meets drier. remove door, set aside. take 2 phillips screws out on other side, set screws aside. remove front of drier by pulling on top left and right sides, front of drier will fall twards front of drier. when it touches the floor lift up on bottom. set aside for later. put new baffels in (you can see where the old ones went) put screws in from bottom 5/16nutdriver. tighten. put drier front back on . start at bottom , snap top back in on both sides. put two screws back on left side, put door back on and replace 2 screws ( door will not go on wrong) test and your done...

we replaced the baffle by removing the broken baffle. There were two screws holding it in place. Door and front panel of dryer had to be removed to accomplish this task. Quite an easy repair/replacement. Thank you for all your help PartSelect.com.

We went to Lowe's to look at a new washer/dryer set. We told the sales lady what our dryer was doing, she said she had that problem before and told us it was probably the rollers had gone bad. The next morning, 5 a.m my wife couldn't sleep so she took the dryer front off, pulled out the tumbler and found the rollers, the lady was right . My wife already had your web site pulled up on the computer so I could look to see what parts I needed. We called to order our parts, we were told it would be 2-5 days before they would get here, they were here the NEXT DAY!!! That was awesome!! I put the new roller on, my wife put everything back together, she turned the dryer on and.... it was so quiet we weren't sure if it was on so I opened the door and held the button to watch it turning, peacefully. Thank you all and the sales lady at Lowe's for saving us $1200. We did our repair with your parts and only spent $85.00.

I took out screws holding top to dryer & raised the top & proped it up to gain access to inside of the dryeeer drum. I then inatalled the new baffle & secured it with 2 screws. It would have been better if the part came with new screws.It was hard to determine which was the right screws for this application.

Go to Youtube and type in the repair (baffle repair). Carefully took apart the dryer as video instructed by unscrewing all necessary parts and took pics of the screws and parts as I went along, so that I could put back together without any problem. I did the repair myself not my husband. I will say, that it helps if you have an extra pair of hands when drilling the nut into the baffle to hold in place. In addition, I used washers to keep nut from falling through since the hole on the drum on one side was big and not holding the nut in place.

1 - unscrewed door
2 - made a mess because the directions did not work for my dryer
3 - figured it out = eventually
4 - popped loose the front panel
5 - unscrewed metal bars (that were holding the top down in the front)
6 - lift front like a hood on a car
7 - unscrew the rest of the front until the drum was loose and I could get to the felt strip
8 - glue new strip on where the old strip was = to the front and back plates that hold the drum
9 - put it back together :)

Following the instructions I pulled off the door and front panel. After rotating drum so the broken baffle was at the bottom I used a socket to remove the two screws on either end. I removed the broken baffle and inserted the new baffle in its place. Reinserted the screws, front panel, and door. I do strongly suggest having the manual handy to view the steps. It's available in PDF format.

The YouTube video on how to replace the baffels was excellent. After watching the video, it was a piece of cake.

take screws out of front of dryer, pull front off to expose drum and replace baffle