Door Seal

Parts Select made it extremely easy to order parts from their site. Parts came in a timely manner and very reasonable priced. Thanks to Parts Select! Door Seal just needed to be removed and replaced by pushing into little slot openings.

It was easy - I had my 12yr old daughter do it. The old door seal was completely removed, then you placed the new seal in the apropriate knoches that are on the door of the dryer. The lint filter just had to be placed in the vent. - Done.

I first confirmed that the ingitor was working (because I could see it glow with the lights off at the bottom of dryer). I read within Parts Select that intermittent heating was likely the coils and that I could test their resistance to confirm that this was the problem. I removed the coils (very easy) and thenI checked their resistance with a tester. The resistance on one of them was reading 600 ohms instead of the required 1300 ohms. So I replaced them both and presto it works fine. I also took the opportunity to thoroughly clean out the lint (accessible with the front panel removed) and I replaced the lint filter which was ripped and the gasket around the door which was missing a piece. All very easy to do and parts select made it a cinch. For safety I made sure that the gas and electric were off before I did any of this work. oh, I also levelled the foot which made my wife happy.

It was easy. Just removed the old seal and plugged the new one in place. Took less than 3 minutes

Pulled the old seal off then pushed the new one in place.

I pulled the old one off and put the new one on. It took about 3 minutes because I also replaced the old lint filter.