Thermal Fuse (Limit: 183) WP306604

My 20 yr old Maytag dryer had experienced this problem about 10 years ago. At that time I replace the Gas Dyer Radiant Flame sensor and it fixed the problem. I figured a sensor went bad again however I opted to replace all of the sensors at once thinking I'm avoiding potential future issues and the dryer will out live me. Replacing the sensors is a piece of cake on my Maytag. A nutdriver and srewdriver was all that I needed. PartSelect was great to deal with and the parts did the trick.

First I took the back and front off and vacuumed up the built up lint. I couldn't see anything glaringly wrong, so I started looking online and found www.partselect.com .
I went through the list of things to check one by one until I found the thermal fuse to be blown. A sticker inside the dryer said "Replace cycling therm. when replacing thermal fuse," so I followed that advice and replaced the thermostat. I followed the directions on the same link.

Dryer has been working fine since. I cleaned lots of built up lint, which it seems may have been the culprit.

My heater element shorted out causing my dryer to overheat and blow the thermal fuse. I replaced the heater element, the thermal fuse, and the High limit fuse. Everything is working perfectly now.

I bought all the recommended parts for this trouble, but it turned out to be caused by burt wire on terminal block causing separation from block as all latches, motor, breakers, elements, switches and thermal sensors tested positive continuity, I finally decided to look in rear panel where incoming power meets terminus to motor, etc. and wires were burnt at ends and post on block was separated from base. I got on phone immediately to customer service to order part shown on their very helpful schematic diagram seen on partselect website. The part was unfortunately discontinued but may be available from other sources. She explained how to search based on part # and the words " terminal block" which directed me to a supplier in MI. Repair completed once appropriate part was received. Thanks again for the direction given even though part was not purchased in the end. Will certainly return to partselect in the future if any issues come up in future. Very helpful site for the DIY'er!!