Average Repair Rating: 2.4 / 5.0, 2 reviews.
What's this?
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Dishwasher made a crunching, grinding sound and then stopped working.
I followed the video available on partselect.com and was easily able to follow step by step the process of removing and reinstalling a new Drain and Wash Impeller and Check Ball.
Mine is a Ultra Wash 111 I followed the repair video on your site but my dishwasher was a little different. Not enough that anyone could still understand the video and not get it disassembled. The video shows two ball checks but mine doesn't use them where the videos shows. I put them in anyway because I called Whirlpool, who made my washer, and they assured me that they should be in there. They got sucked through the dump impeller and plugged the discharge tube so I had to disassemble it again and take the ball checks out. Lucky for me nothing got damaged. I then got a hold of someone on your chat line that got me to the correct parts view that shows where the ball check is suppose to go on my washer. During working on my washer I realized the squealing was because the bottom bearing on the motor needed oil. So all and all I'm happy because it runs quiet and it works fine. Thanks Greg
Ask our experts a question about this part and we'll get back to you as soon as possible!
1 question answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Gary
December 27, 2019
My dishwasher had 3 checkballs, 2 large and 1 small. During gasket replacement what is the proper re-installation sequence for the small checkball? I removed one large from the top, one large was found at the bottom after the screw and cover were removed. The small checkball mysteriously appeared in my parts tray. I guess that it had stuck too the cover that i removed. How do i insert it during reassembly/
For model number 66515689000
Good Day Gary. Thank you for your question in regards to your unit (Model Number 66515689000). Based on our research, the smaller check ball goes with Inlet Base Seal that is attached to the Inlet Base (underneath the Pump Filter and Housing Assembly). The two larger check balls go with Drain Cover Seal on the Darin Cover above the Pump Base. The following video may be able to help you with what you are looking to do: https://www.youtube.com/watch?time_continue=29&v=dtFu8e7MQ-8&feature=emb_logo. Hope this helps. Best Regards.
3 people found this helpful.
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this part and we'll respond as soon as we can.
This dishwasher drain and wash impeller kit comes with both the drain and wash impeller, gaskets, chopper and installation screw. This part helps stop your dishwasher from leaking and helps with the proper draining of t...