Electronic Control Board

Temp is good. Problem is the condenser and evaporator fans are cutting off for a few seconds then come on for a few seconds then cut off. This is all day long. On and off every few seconds. It started last week with them going off and coming right back on about every hour. Now its all the time. Never on for more than a minute. Control board?

My refrigerator is continuously cycling on and off. Like on for 10-20 seconds, then off, then on again...etc.i had it looked at and without too much measuring, the technician told me i needed a new control board. told me that it is discontinued. does that make sense?

When installing the control board with a new control board , is there any special process or just unplug it and plug it back in ?

I have an ongoing problem where the refrigerator is working fine, then it shuts off and the damper that feeds cold air from the freezer section to the refrigerator section makes a sort of buzzing or vibration sound twice, then i hear 2 beeps coming from the bottom of the refrigerator and it just keeps doing that very same sound and sequence. In the meantime, it’s not running really, the condenser fan is off, compressor is off, lights are on and the electronic display is fine as well. So what i have to is “reset” the electronic temperature control display by pressing the holiday mode button and on/off button at the same time for 10 seconds or so and then i hear the fan come on, compressor kicks on and will operate fine for a couple of days and now this even5 is happening more frequently. I have a video of it if will help you see it fir yourself. I am thinking that the electronic control board is an issue bu5 not sure.

I set my freezer to (0) and refrigerator to (37); shortly thereafter the numbers changes to something else. What is the problem?

I am needed a new control board. The whole model number is kscs 251 inss01. I am pretty sure the control board number for this model is 2307037. But because it is now under Whirlpool i want to make sure i am purchasing the corret item. My sears service man said he could not find the correct control board, this was after two attempts.

How to open plastic cover to replace small base light sockets. Both lights burned out and new ones still don't work. Door switch working.

My KitchenAid refrigerator kscs23inss01 is not cooling at all (although the lights are on) and there is no display in the control box. I used multi meter and found there is only a very low voltage on the wires connected to the part wp2307037. How to check if the part wp2307037 is bad or not? What is the required input voltage for this part? Many thanks!

Would this be the correct control board if the refrigerator is not running at all. Power is on to the fridge, temp displays state 70 and 70, water dispenser still working?

Not getting the cold temp. If i unplug the power supply and plug it back for after a couple of minute, the beeping noise of compressor and fan can be heard also the control board lights get started on and off for one or two minutes. After few blinking, cold air gets started and fridge run for app. 30-40 minutes and then shuts off compressor and fan but lights are on. Technician told me to buy a new control board but he also mentioned that because of this model discontinue, requires new wiring and plug. Please advise the right part number for control panel and if it requires the service kit also to replace it.