Door Shelf Retainer Bar End Cap - Left Side

Followed directions enclosed with new ice maker.
1. Unplugged refrigerator. Removed three screws holding ice maker with a 1/4" nut driver while supporting ice maker with free hand
2.After removing ice maker from sidewall, unplugged wire pigtail and removed entire ice maker unit
3. Installed new pigtail, and bail wire from old ice maker, onto new ice maker
4. Holding ice maker with one hand, inserted new pigtail into plug, aligned water fill tube and held unit in position to reinstall 3 screws with 1/4" nut driver
5. Set wire bail in down position, plugged refrigerator power cord back in. About an hour later had new ice cubes.
This was a much easier job than I had anticipated. Thank you PartSelect! I am a happy camper once again. This refrigerator is in my motorhome.

My wife had the shelf end caps and trim replaced before I got home. The shelf support stud was very easy to install. A pair of pliers and a simple turn and the broke piece was out and the new one was in.

To get the broken end cap off of the retainer bar, hold the retainer bar still and pull the broken end cap straight off on a line that is parallel with the retainer bar, and with a little tugging. Might even have to tap the end cap lightly. Slide the new cap back on to the retainer bar and then put the end cap back into the door slot by putting the bottom of the end cap into the slot first by tilting the upper part back a little, then pushing down on the end cap to get it down into the slot far enough to let the upper part go in. Then adjust the end cap up slightly to cause it to snap into place.

I myself unwrapped the plumbers tape I had holding the shelf and retainer bar ends together until I received the replacement part. I snapped the retainer bar into the door and yahoo, all fit and was snug and I now have two replaced working shelves. It was great! Thank you for ALL that your site did!!

Replaced shelf retainer end clip left side.

Removed the old ones , this was easy because the clip part of the end cap was broken off. I simply
inserted the plastic clip part if the new end cap into the slot in the door and presto it was done.
Then I replaced the other end cap the same way

The repair went very smooth, and fast. First I made sure I looked at markings for correct side. I snapped bottom in first and top snapped right in.

removed owner applied "tape" and broken end caps from shelf.replAced end caps and snapped back into door slots. very simple operation but
the highlight was relative ease in finding parts at partselect. i was afraid given the age of refridgerator i would not be able to find replacement parts.once i found their website and described part it popped up in-stock and in several different colors. THANKS PARTSELECT!!

Haven't used the bottom door shelf of my refrigerator for years, lived with a lint filter on my hand-me-down dryer that was taped with electrical tape since the day I inherited it, and loaded and unloaded my dishwasher with irritation because of a broken clip on the bottom rack. Ordered the parts from PartSelect and got them in just 2 days. Fixed all three problems in about 15 minutes total. It's like getting new appliances...why didn't I do this sooner?

This was a really simple repair, but Parts Select made it super simple. The website was really easy to use and the parts arrived very quickly. I'm glad I found this website! Thank you!