The roller glide in your microwave rests under the microwave plate, and allows it to rotate when the microwave is running. It is a round plastic ring with 3 wheels spaced out around the perimeter. If ...
Ask our experts a question about this model and we'll get back to you as soon as possible!
1 question answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Bryon
February 18, 2020
Microwave stopped dead in it's tracks. Help
For model number PEB7226EH2ES
Hello and thank you for writing.
It certainly sounds like it could be a faulty switch PS237416 and/or possibly a malfunctioning thermostat PS8754466 you should check the part(s) for signs of damage or test with a multimeter, and replace the part(s) as needed. We hope this helps. Please contact us anytime if you require further assistance.
First, I read the PartsSelect DIY report by Linda, Warsaw, IN. With confidence, I purchased the magnetron. Upon receipt, I took the built-in microwave out of the cabinet, set the unit on the kitchen floor, and was stopped cold by the Safety Torx nuts on the reverse of the unit. Borrowing the right wrench allowed the 20 minute start-to-finish part changeout and reinstallation of the unit in the cabinet to proceed. The old magnetron was the defective part. Discovery of the 10-year Parts-Only warranty on the less than 10-year old unit was insufficinet to guide me to take the unit in for their Labor bill to repair. New part in hand, it just was that easy - and assumed to be no less expensive.
1. Unplug the microwave, or cut power at the fuse box. 2. Clean the microwave in case there is any food splatters or residue. 3. Using a flathead screwdriver, pop off the plastic rivets that hold the waveguide cover in place. They should not take much to pop out. 4. Replace the damaged waveguide cover with the replacement, reinsert plastic rivets. 5. Restore power to the microwave and test.
