Models
>
MWT4661WW
MWT4661WW Caloric Microwave - Overview
Sections of the MWT4661WW
[Viewing 1 of 1]
Keep searches simple, eg. "belt" or "pump".
Light Bulb - 40W
PartSelect #: PS2376034
Manufacturer #: 8206232A
This 40w light bulb is a replacement bulb constructed of glass and metal. It is an easy-to-install electrical part which produces 40w of light. If the bulb won't light up then it may be broken and sho...
$11.29
In Stock
Grease Filter
PartSelect #: PS2172373
Manufacturer #: R0710162
This metallic grease/air filter collects grease particles in the air from cooking. This filter is also removable for cleaning.
No Longer Available
Microwave Door Interlock Switch
PartSelect #: PS11742843
Manufacturer #: WP56001036
$67.84
Special Order
Rack Support
PartSelect #: PS2195826
Manufacturer #: Y05200084
Sold Individually.
No Longer Available
Door Handle
PartSelect #: PS2172186
Manufacturer #: R0705978
This white door handle assembly is nine inches long.
No Longer Available
Rectifier
PartSelect #: PS11738693
Manufacturer #: WP13091701
This part is also known as a rectifier.
$33.04
Special Order
Questions And Answers for MWT4661WW
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
light bult needed to be replaced
The nightmare was that this microwave is installed under the cabinet....in order to get to the light bulb I had to pull out my stove then squeeze into the space between the stove and counter....my old microwave light bult was much easier to change.....Shame on Whirlpool for making this so difficult.....must be a better way to cover the light bulb so that we do not need a screwdriver to remove the door to get to the light bulb
Parts Used:
-
Deborah from Millersville, MD
-
Difficulty Level:Difficult
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
203 of 297 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Bulb "burnt out"
Removed 1 screw, removed "burnt out" bulb and replaced it with new bulb.
Parts Used:
-
Joseph from Pembroke, MA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
93 of 146 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
door handle broken during pulling door open
1. Researched the Internet
2. Removed the inner door panel (part way)with the
putty knife exposing the screws which were I
removed to get the old handle off.
3. Attached the new handle with the old screws
since the new part came WITHOUT screws.
4. Pushed the inner door panel back in.
5. Voila! Good as new.
2. Removed the inner door panel (part way)with the
putty knife exposing the screws which were I
removed to get the old handle off.
3. Attached the new handle with the old screws
since the new part came WITHOUT screws.
4. Pushed the inner door panel back in.
5. Voila! Good as new.
Parts Used:
-
Stephen from Beech Mountain, NC
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:30 - 60 mins
-
Tools:Screw drivers
24 of 29 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!