This bake element has push-on terminal ends.
NOTE: This element has been updated by the manufacturer. New installation screws are required. Screws are sold separately.
$50.69
In Stock
Order within the next 9 hrs and your part ships today!
The filter is made of metal and is intended for use with ranges and cooktops. As per the manufacturer, this filter may be 1/2" slimmer than the original, but will still function the same.
$38.89
In Stock
Order within the next 9 hrs and your part ships today!
The oven sensor detects the temperature within the oven cavity and sends the information to the control board. If your oven is not heating evenly, has little or no heat when baking, or is too hot, you...
$53.22
In Stock
Order within the next 9 hrs and your part ships today!
This 6-inch, 1200-watt radiant surface heating element is a genuine replacement part designed for select ranges. It supplies consistent heat to the designated cooking zone on the stovetop, ensuring ev...
$217.02
In Stock
Order within the next 9 hrs and your part ships today!
This part is a replacement halogen lamp for your oven. The bulb is 25 watts and 120 volts. If your light bulb is burned out, this is the part that replaces it. Be sure to turn off power to your range ...
$32.66
In Stock
Order within the next 9 hrs and your part ships today!
This surface burner switch, also known as an infinite switch, is a key electrical component that controls the heat output of your stovetop burners. When you turn the control knob, the switch adjusts t...
$115.24
In Stock
Order within the next 9 hrs and your part ships today!
This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch...
$26.58
In Stock
Order within the next 9 hrs and your part ships today!
The Dual Radiant Surface Element with Limiter is an OEM replacement designed to efficiently distribute heat across the cooking surface of ranges. Equipped with a limiter for safety, it prevents overhe...
$243.72
In Stock
Order within the next 9 hrs and your part ships today!
Keep your oven safe and functional with this replacement interior door glass, the heat-resistant panel that lines the inside of your oven door. With dimensions of approximately 20 5/8" x 13 1/8", it f...
$160.20
In Stock
Order within the next 9 hrs and your part ships today!
This switch is used to operate the dual surface burner.
$112.85
In Stock
Order within the next 9 hrs and your part ships today!
Questions And Answers for JES9800AAB
Ask our experts a question about this model and we'll get back to you as soon as possible!
8 questions answered by our experts.
< Prev
1
2
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Luke
November 15, 2022
The display shows both elements turned on during baking cycle warmup, but the broil element never glows like the baking element. The broil element works fine during broil cycle. Should both elements be on during baking?
For model number JES9800AAB
Hi Luke, thank you for contacting us. Generally, the bake settings use only the lower element. Preheat setting turns on both elements, it is the setting to use for recipes requiring a cold start in the oven. After the warmup, the oven switches to the bake element and maintains the temperature with only the lower element. We hope this helps!
2 people found this helpful.
Was this helpful?
Thank you for voting!
Joe
July 12, 2023
Control panel alarms and scrolls F1-1 call authorized dealer when appliance is not in use
For model number JES9800AAB
Hello Joe, thank you for contacting us. The F1-1 error code means that your oven thinks your lower oven sensor is shorted. Power unit down by turning off the circuit breaker(s) for one minute. Power unit up by turning on the circuit breaker(s). Monitor the oven for one minute to ensure the error code does not display again. Verify oven operation. If it does not solve the problem, we recommend replacing the temperature sensor, part number PS1570174. We hope this sorts out your problem!
I need the two phase burner looking at the stove the right front
The center works but the outside ring doesn't
Any suggestions
For model number JES9800AAB
Hello Joe, thank you for reaching out. Before replacing the surface burner, we would suggest checking the infinite switch, part number PS2003583, to fix the issue. It turns the surface element on and off and controls how much heat the element produces. We hope that helps!
What is the difference between the AAW and AAB model? I need an ignition switch for my JES9800AAW range.
For model number JES9800AAB
Hello Ardner, thank you for your question. JES9800AAW is a white unit. JES9800AAB is a black unit. The switches for both models would be the same. If you need help placing an order, customer service is open 7 days a week. Please feel free to give us a call. We look forward to hearing from you.
Was this helpful?
Thank you for voting!
Derek
January 24, 2025
Hi do you know if the glass top for the 9800aab is compatible with the model 9800aas?
For model number JES9800AAB
Hi Derek,
Thank you for your question. Yes, the cooktop is the same for both models. We hope this helps!
Was this helpful?
Thank you for voting!
< Prev
1
2
Next >
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
First, I unplugged the oven. Then, I removed the two screws that hold the element in place. After that, I gently pulled the element toward the front of the oven until the wires were exposed. I disconnected the wires from the old element, removed the old element and then attached the wires to the new baking element. I gently pushed the new element back into the screw holes and screwed the new element in place. When I plugged the oven back into the wall I heard a pop and thought I'd blown up the oven! Turns out the breaker popped...after fixing the breaker, I turned the oven on and the element worked just fine. I highly recommend PartSelect.com for their fast shipping and great products. I will be ordering from them again for future appliance parts.
Turned the breaker off, I removed 2 screws securing the range top to the range, opened the top and secured it in the up position, Removed the 2 screws securing the element ,one at a time I swapped the quick connectors from the old element to the new and repeated the process in reverse. I save over $100.00 in labor, plus most companies get you for a trip charge. It was easy!!
