This surface burner head is for ranges. Surface burner head distributes the gas through holes or slots to create an even flame across the cooking area.
Ask our experts a question about this model and we'll get back to you as soon as possible!
1 question answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
STEPHANIE
February 21, 2023
THE WARMING OVEN IS JAMMED AND WILL ONLY OPEN ABOUT 6 INCHES, A BAKING PAN IS BLOCKING IT FROM OPENING. DO I NEED A REPAIR PERSON TO FIX IT
For model number HDIP054U
Hello Stephanie, Thank you for your inquiry. You can try using a stick or long utensil to try and unjam the baking pan that is causing the blockage. If you open the larger oven door, there is usually a small gap between the oven door and the front of the oven when the larger door is fully open and this might be enough to push something in there to try and unjam the pan. You can also try pulling the stove out and removing the back panel to see if that will allow you access to the drawer to remove the pan. We hope this helps.
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
First, cut the power and remove the oven from the cabinet.
The bake element is accessible from the back and sits in a drawer.
As someone else said, you have to use pliers to bend the cover of the drawer, you will make some damage to the cover, but there is nothing you can do about it.
Make a note of what wire goes to the right and to the left so you can plug them back like it was before.
When you replace the bake element, make sure you insert it in the straps so it won't wiggle when it heats.
To close the cover that you bent, you will need a helper and push really hard.
Watch the YouTube video. Turn off power or unplug the range. Remove 5 gas control knobs. Remove four T20 screws on Control panel. one on each end, L and R, two underneath, L and R. Pull off control panel and carefully flip it up onto the range, being careful not to stretch the wiring harness. Carefully remove two wiring connectors (pinch and pull method) Remove four T20 screws securing the Control panel mount then turn it over 180 degrees. Straighten the mounting tabs until the control panel easily slides off of its mount. Remove and replace the control panel and sheet. Reverse the procedure to reinstall. It took me longer to clean the components and the area that to repair the problem. Tip: Isopropyl alcohol in a spray bottle and a cloth cuts the grease and grime, if needed, with very little effort and no scratching.