This is a replacement O-ring for the drum bearing retainer on your dryer. The drum bearing is found at the back of the dryer drum. The O-ring is designed to create a seal on the drum bearing. The O-r...
This OEM replacement dryer slide bearing is white in color, and approximately 3 inches long. The slide bearings are supportive linings for your dryer. If they have eroded, or are damaged, the drums wi...
Ask our experts a question about this model and we'll get back to you as soon as possible!
3 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Raymond
August 9, 2023
Motor sounds like it is on when you push the start button, but the drum doesn't turn and when you release the start button everything turns off. Could the push button be the problem?
For model number GTD42GASJ1WW
Hi Raymond, thank you for getting in touch. The issue could be with the push-to-start switch, part number PS3487190. We hope this helps!
I’m in need of a LP (propane) conversion kit for this model.
For model number GTD42GASJ1WW
Hi Lucas, thank you for your inquiry. The LP conversion kit you are looking for is part number PS11729223. If you need help placing an order, customer service is open 7 days a week!
Was this helpful?
Thank you for voting!
Dennis
February 8, 2024
The control know no longer clicks when turned, and will not work on different selections.
Could I only need to replace the control knob ?
For model number GTD42GASJ1WW
Hello Dennis, thank you for reaching out. Based on our understanding of the issue, we would suggest replacing the timer, part number PS11763064, before replacing the knob. It controls the electrical components and the duration of the dryer cycles. Glad to be of assistance!
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
Removed the front Dryer panel. Left drum in place and lifted it up slightly to get access to motor drive. Slipped belt in place and put panel back on. This was a first attempt ever at fixing an appliance and it was no big deal.
First I found and watched three videos on how to open the dryer and replace the igniter. Then I opened the dryer, but I did not remove the belt as suggested in the video, and then I removed the ignitor and flame detecter as the videos had shown. I got on-line and ordered the new parts from PartsSelect in the afternoon and had them in my hands the next morning by 9:30 am. I installed the new parts and everything worked fine again. You must be very careful with the igniter to not touch it with hands or anything else. I practiced puting in the old parts first.
I had to take most of the dryer apart because there is no rear access to the motor. It turned out to be easy to dissasembel the dryer. The only problem that I had was that I could not figure out how to route the belt around the motor and the idol pullies. I could not find anywhere that gave instructions on how to properly tension the belt. I finally figured out that the idoler pulley needs to be locked in place on the right side of the engie mount. Then the belt needs to be routed over idoler pulley and under the motor pulley. Finally release the idoler pully from the locked postion to put tension on the belt. It really turned out to be pretty easy.