This part is a replacement wheel assembly for your lower dishrack. The wheels on the dishrack allow it to roll in and out of the dishwasher efficiently. If one of your wheels is broken or warped, you ...
$31.65
In Stock
Order within the next 4 hrs and your part ships today!
Looking for a way to fix that leaky Frigidaire dishwasher? Let's get it solved with this genuine OEM door seal. This part is key to creating a leak-proof barrier between your dishwasher's tub and door...
$109.52
In Stock
Order within the next 4 hrs and your part ships today!
Experience the peace of mind that comes with a perfectly functioning dishwasher again. Introducing the Frigidaire Door Spring & Cable Assembly ? your trusted solution to those troubling sudden door dr...
$38.00
In Stock
Order within the next 4 hrs and your part ships today!
Are you having trouble with your dishwasher's water flow? Perhaps it?s time to consider this replacement part - the Frigidaire Water Inlet Valve. Made specifically for specific models of Frigidaire di...
$94.11
In Stock
Order within the next 4 hrs and your part ships today!
Have your dishwasher work like new with this genuine OEM SEAL KIT, CABINET from Frigidaire. This kit is designed to offer a solution to your moisture problems, helping to prevent condensation build-up...
$139.24
In Stock
Order within the next 4 hrs and your part ships today!
Remove front Fascia on floor, use AC sniffer find hot wires into unit. Flip circuit breaker at panel. Verify no AC, shut water valve off on Dishwasher supply. Disconnect two valve wires to solenoid. Use wrench set to find proper size and use to remove supply line. Unscrew two Phillips sheet metal screws that hold valve support bracket and remove bracket with it now being held in by water inlet valve hose to interior wall of Dishwasher. Use Tin Snips to cut off metal band securing hose to old water inlet valve. Place new valve onto inlet hose, secure with new hose clamp (you must supply) tighten hex nut on clamp till water tight. Fasten wires onto the solenoid and mount assembly support bracket to dishwasher. Now connect water supply line after wrapping threads with pipe dope tape fasten and secure nut with adjustable wrench till water tight open supply valve and look for leaks with a flash light. If no leaks, reset breaker and test run and drain. No leaks replace fascia and have a Beer great Job saved $850 min. on a new dishwasher!
Preface: I had to remove the dishwasher anyway since I was replacing cabinets. So sitting in the garage it took less than 10 minutes to replace both sides. If I had to do this with dishwasher installed...2 screws pull dishwasher out 6 inches, unhook the spring, unhook the cable, hook new cable, rehook spring. Dido for the other side, slide dishwasher back in place reinstall attachment screws. All that...max 30 minutes. So easy.
Very easy. Was able to pop on the new wheels with no problem. Earlier orders of wheels (from another company) were close, but no cigar. These fit with no effort.
