Kelvinator Dishwasher Spray Arms

Lower Spray Arm

★★★★★

★★★★★

103 Reviews

The Lower Spray Arm is used in your dishwasher to spray water and clean your dishes. If broken there will be visible damage or your dishes may no longer be cleaned properly. If your spray arm is broken (due to general wear or high heat), it should be replaced. Your lower spray arm will be located at the bottom of your dishwasher tub. Check your user manual and model number to ensure this model is right for you. This version is plastic and metal and comes in gray/blue. We recommend you wear work gloves to keep your hands safe when installing and disconnect power to the appliance. You will also want to make sure that you turn off the water supply to your dishwasher. From here, you will want to open the dishwasher, pull out the lower rack and set it aside. Remove the lower wash arm. On each side of the bottom of the spray arm, there are small locking tabs that can be pushed aside using a flathead screwdriver. Once released, the spray arm can easily be pulled off the dishwasher. Put the new lower wash arm in place and push it down to lock it in. Ensure it is spinning freely and does not hit the heating element. Return the lower dish rack into place and then close the dishwasher door.

Upper Spray Arm

★★★★★

★★★★★

31 Reviews

The upper spray arm helps distribute water from the top of the dishwasher tub.This spray arm is a genuine OEM replacement part for your dishwasher. This spray arm is for the upper part of your dishwasher. No tools are required for this repair, simple remove the rack stops and upper dish rack, then disassemble the mount and spray arm before installing the new one.

Spray Arm Depending on your model number, this spray arm is either the upper arm or center arm.

Wash Arm Support and Pump Cover

★★★★★

★★★★★

1 Review

Lower Tower Assembly This tower helps force the water being propelled by the pump and motor assembly up to the spray arms for continuous water pressure during the wash cycle.

BASE

Wash Arm Support and Diffuser Assembly