International Washer Springs and Shock Absorbers

Snubber Ring

★★★★★

★★★★★

16 Reviews

Damper Pad Kit

★★★★★

★★★★★

2 Reviews

This damper pad kit is used for base support. It comes with three six inch damper pads, two little tubes of lubricant. NOTE: This part will need adhesive to stick it in place.

Motor Pivot Spring This part is the replacement motor pivot spring for your washer. It is made of metal and is approximately 3 inches long and 2 inches wide. The motor pivot spring helps hold the drive motor in the correct position on the motor plate. If your drive motor shakes during use, if the pumps will not operate, or if your washer is excessively loud during operation, you may need to replace the motor pivot spring. Be sure to disconnect the washer from the power source before you begin this repair. This part is sold individually and is an OEM part sourced directly from the manufacturer.

Tension Springs -Set of 2

★★★★★

★★★★★

2 Reviews

This is a set of 2 tension springs.

Glide and Spring Kit

★★★★★

★★★★★

1 Review

This glide and spring kit contains two three inch springs, four one inch square glides, and two tubes springs. This kit replaces older style round roller glides.

Timer Knob Spring This timer knob spring is almost an inch and a half long, and is not quite an inch in diameter. It is made of metal and is used with the timer knobs of both washers and dryers.

Lid Switch Actuator Spring This lid switch actuator spring is exactly one inch long. It is made of metal.

Brake Spring

Unbalanced Plunger When this part is used along with the lid switch, it can tell the motor of the washer to stop when a load is uneven. The washer will not start up until the lid is opened and then closed again.

Unbalance Lever Assembly