Dryer Wheels and Rollers
Find your partEnter your model number or a part number and click "Search"
Popular Dryer Wheels and Rollers
PartSelect Number PS373087
Manufacturer Part Number 4392065This consists of a belt, two roller wheels and an idler pulley.
Drum Support Roller Kit
PartSelect Number PS1570070
Manufacturer Part Number 12001541This drum support roller includes one drum roller and two bearings. Most dryers use two drum rollers, and it is recommended to change both at once.
Dryer Drum Support Roller
PartSelect Number PS11752609
Manufacturer Part Number WPW10314173This is a drum support roller for a dryer. It is a genuine replacement part. The part includes the drum roller only and does not include the tri-rings. This part is sold separately. Most dryers require two drum rollers. It is recommended to check and replace both drum support rollers at the same time to ensure proper drum rotation and because they often wear at the same rate. The drum support roller holds the drum in the proper position while it spins on the support wheels. If rollers are worn out, they will cause the dryer to be noisy. This repair has been rated as "medium" difficulty by our customers, generally taking between 30 and 60 minutes. Make sure to disconnect the power, gas, vent lines before commencing this repair. You may require a nut driver, pliers, screwdriver, and wrench for this repair.
PartSelect Number PS334244
Manufacturer Part Number 279640This Idler Pulley includes the tri-ring and gasket and everything included here is manufacturer-certified. This part maintains correct tension on the drive belt in order to spin the drum properly. If damaged or broken the dryer will not dry properly, will not tumble properly, or may not even start. Installation is rated as "Medium" difficulty. This part is located on the dryer drum, around the tension pulley. Refer to your user manual and model number for repair instructions and to ensure this part is right for you. For this repair project, the tools needed are a Phillips screwdriver, 1/4 inch nut driver, putty knife, small flat blade screw driver, and needle nose pliers.
Rear Drum Support Roller Kit
PartSelect Number PS347627
Manufacturer Part Number 349241TThis kit includes two rear drum support rollers, four tri-rings, and one palnut. It is recommended that you replace both rollers at once.
Blower Wheel with Clamp
PartSelect Number PS2200270
Manufacturer Part Number Y303836This blower wheel comes with a metallic hub clamp to hold it firmly in place.
Fixes these symptoms
- Too hot
- See more...
Drum Support Roller
PartSelect Number PS11741913
Manufacturer Part Number WP37001042This single drum support roller is used for square ported model clothes dryers. It has a metallic bearing in its center.
Idler Pulley Wheel
PartSelect Number PS265721
Manufacturer Part Number WE12X83A dryer's idler pulley wheel serves to help the belt to rotate the drum.
Blower Housing with Blower Wheel
PartSelect Number PS418726
Manufacturer Part Number 131775600***Please Note: This part is a substituted part by the manufacturer. It may appear different, but should still work with your appliance.
Drum Support Shaft - Rear Shaft with Right Hand Threads
PartSelect Number PS11753708
Manufacturer Part Number WPW10359272Shaft for dryer drum support roller. Rear shaft with left hand threads. Part is updated so nuts may need to be replaced as well on older dryers.