Admiral Dryer Wheels and Rollers

Maintenance Kit

★★★★★

★★★★★

76 Reviews

Includes Belt 8066065, Rollers WPW10314173, Pulley 691366, Clip 90296, Tri-ring W10512946. 4 Roller Kit 4392067

Rear Drum Support Roller Kit

★★★★★

★★★★★

41 Reviews

This kit includes two rear drum support rollers, four tri-rings, and one palnut. It is recommended that you replace both rollers at once.

Idler Pulley

★★★★★

★★★★★

54 Reviews

This Idler Pulley includes the tri-ring and gasket and everything included here is manufacturer-certified. This part maintains correct tension on the drive belt in order to spin the drum properly. If damaged or broken the dryer will not dry properly, will not tumble properly, or may not even start. Installation is rated as "Medium" difficulty. This part is located on the dryer drum, around the tension pulley. Refer to your user manual and model number for repair instructions and to ensure this part is right for you. For this repair project, the tools needed are a Phillips screwdriver, 1/4 inch nut driver, putty knife, small flat blade screw driver, and needle nose pliers.

Drum Support Roller

★★★★★

★★★★★

7 Reviews

This single drum support roller is used for square ported model clothes dryers. It has a metallic bearing in its center.

Drum Roller Shaft - Left Side Replace the shaft of your left side drum support roller with this part from Whirlpool/Kenmore. This replacement shaft is 2-7/8 inches long. It is meant for use with many of Whirlpool/Kenmore's gas and electric clothes dryers that have been manufactured since 1965. Also known as Drum Roller Shaft.

Drum Support Shaft - Rear Shaft with Right Hand Threads

★★★★★

★★★★★

3 Reviews

Shaft for dryer drum support roller. Rear shaft with left hand threads. Part is updated so nuts may need to be replaced as well on older dryers.

Drum Support Roller Shaft - Right Side Replace the shaft of your right side drum support roller with this part. This replacement shaft is 3-3/16 inches long, but does not require a washer or a nut.

Drum Support Roller Shaft - Right Hand Threads This shaft is for the front with right hand thread. Sold individually.

Blower Wheel

★★★★★

★★★★★

2 Reviews

Part may differ in appearance, but functions same as original part.

Drum Support Roller and Shaft Assembly This drum support roller bracket and shaft assembly is a little over two inches long. It is made of metal.